This map of the frozen wall, published January 17th shows the current status of the project. Most of the sea side and flanking walls are fully frozen according to the sensors TEPCO uses to monitor the wall.
Sections of the land side wall show clear gaps. These locations are where they have opted to not turn on the equipment. This was done to allow water to flow into the reactor building area to prevent the ground water from dropping too low, causing contaminated water to leak out of the reactor buildings.
Sea monitoring and discharge canals closer to the port still show indicators that contamination may be leaking out as those locations have not decreased further since the wall system was fully frozen.
This article would not be possible without the extensive efforts of the SimplyInfo research team
Join the conversation at chat.simplyinfo.org
© 2011-2016 SimplyInfo.org, Fukuleaks.org All Rights Reserved Content cited, quoted etc. from other sources is under the respective rights of that content owner. If you are viewing this page on any website other than www.simplyinfo.org (or www.fukuleaks.org) it may be plagiarized, please let us know. If you wish to reproduce any of our content in full or in more than a phrase or quote, please contact us first to obtain permission.